TI Drive Shaft Enclosure Kit

Description

Save almost half the weight with this Titanium Drive Shaft Enclosure!

A minimum 12” enclosure which covers the slip yoke and drive shaft is required in many classes by major sanctioning bodies in order to protect a driver by retaining a broken or lose drive shaft in the event of driveline failure.

TMRC’s extreme duty Drive Shaft Enclosure creates a double layer of containment with its floating tunnel design. Unlike basic designs where the enclosure is welded to a drive shaft loop(s), this system allows the enclosure tube to take the initial impact of a driveline failure and often retains a drive shaft without causing damage to the outer loop(s). Repair or replacement of the enclosure tube is much easier and less expensive than replacing an entire unit that is welded to its outer loop(s).

The second layer of protection in the TMRC Drive Shaft Enclosure system is an ultra-strong Removable Drive Shaft Loop that features superior strength and quality.

TMRC’s Drive Shaft Enclosure Kits are available in several configurations for use with multiple transmission and drive shaft combinations.

Check out the video below for a detailed look at our Drive Shaft Enclosure Kits and available options.

Standard in each kit is a 18” long piece of our 6″ X .050″ wall enclosure tube, quick release mounting tabs and bracket for a Lenco or B&J transmission (choose when ordering).

Use the included T-Spud and quick pin at the rear of the tube along with a Removable Drive Shaft Loop (Not Included) for a solid installation.

*Complete kits with loops and designs for automatic transmissions are also available.

Includes:
• 6” X .050” Drive Shaft Enclosure Tube X 18” Long (1)
• Transmission Mounting Bracket (1)
• T Spud (1)
• Mounting Tab (4)
• Quick Release Pin (2)
• Detailed Instructions