Roof Safety Panel Kit

Description

The Roof Safety Panel Kit can be installed to protect drivers in the event of an accident where a vehicles body is removed from its chassis. (See overview and installation video below.)

This kit provides you with a 42” X 24” Carbon Fiber Panel that can be trimmed to fit around the funny car cage and roof area then extend to the centerline of the vehicle. The included 4130 strip can be attached to the carbon panel at the centerline to prevent chipping or fraying from working inside the vehicle.

Attaching the Roof Safety Panel requires no welding. Simply use a combination of the 10 included rubberized clamps to secure the panel to the roll cage.

This configuration is required for NHRA Pro Modified in 2015 and PDRA competition. Cars built after the 2015 rule require a weld-in version (TMR-1263KA) which is available as well.

See a full list of included components below.

Clamp-On Version Includes
– 42” X 24” Carbon Fiber Panel (Trim To Fit)
– 42” X 1.5” Strip of 4130 Plate (Used On Centerline Edge)
– 6 Rubberized 1-1/4” Mounting Clamps
– 3 Rubberized 1-1/2” Mounting Clamps
– 1 Rubberized 3/8” Mounting Clamp
– Stainless Screws & Washers For 10 Clamps

Weld-In Version Includes
– 42” X 24” Carbon Fiber Panel (Trim To Fit)
– 42” X 1.5” Strip of 4130 Plate (Used On Centerline Edge)
– 10 Weld-On Tabs with Nutserts
– 4130 Center T Support
– Stainless Screws & Washers For Tabs